Gasoline, diesel, kerosene, E85, and non-potable water. Do not use with drinking water, chemicals, or solvents.

No. This model uses a manual flow-control nozzle—squeeze to start, feather for precise flow, release to stop.

Up to 3.2 GPM (12 LPM), typically transferring a gallon in about 20–30 seconds depending on head height and fluid.

Two included options: AC 120V adapter and DC 12V battery clips. You can also use 2×AA batteries as an emergency backup (not included).

Discharge hose: 4.25 ft (51 in / 130 cm). Suction tube: 19 in (48 cm).

Yes—compatible with many Scepter gas cans using the included adapters. Not compatible with FMD / Smart-Control spill-proof cans.

Fuel transfer pump with manual flow-control nozzle, DC cable with 12V clips (1 set), AC/DC adapter (1 set), gas can adapters (2" & 3.8"), and instruction manual. *Gas can & batteries not included.*

41–113 °F (5–45 °C).

Place the discharge end firmly in the receiving tank, start with a light squeeze, then increase as needed. Release fully to stop flow before removing the nozzle.

For DC: connect red clip to (+), black clip to (–) on a 12V battery away from open fuel. For AC: plug into a grounded outlet. Keep all connections dry and away from fumes.

Use only manufacturer-approved accessories. Unapproved hose/nozzle changes can reduce performance, introduce leaks, or void warranty.

After use, let residual fuel drain back to the source. Wipe exterior with a dry cloth. Store in a cool, dry place. Do not flush with water if used for fuel.

Store away from heat, sparks, or flames. Keep out of reach of children. Always ground the fuel container, avoid static, and use in a well-ventilated area.

• Confirm power (AC/DC connected, fresh batteries if using AA).
• Check the suction tube is fully submerged and not drawing air.
• Straighten the hose—remove kinks or restrictions.
• Verify the nozzle trigger isn’t partially engaged.

1-Year Full Replacement Warranty and 30-Day Money Back. Plus, FREE Fast Shipping.